C3A, C6A, C6A HDVideoColposcope User ManualApplication of the Video Colposcope Software
- 49 -
4) Deleting an Image
Click the Delete button underneath the image to delete it. A prompt is issued. Click Yes to
confirm the deletion, or click No to cancel it.
If multiple images are available, you can click or to switch to the
previous or next image and then edit it in the same way. ClickExit or to close this page.
5.4.9 Measuringan Image
Right-click an image in the Current Patient ImageareaandchooseImage Processing. The Image
Processing page is displayed. You can measure the image on the Image Measuring tab. Perform
calibration before measuring the image. You can choose manual calibration or default calibration.
NOTE:
1. If you choose default calibration, keep the camera at a distance of 25cm from the
target in vertical direction while capturing images, and make the calibration
magnification consistent with the actual magnification.
2. In default calibration, magnifications for C3 camera, C6 camera and C6 HD camera
are 1-28 times, 1-36 times and 1-50 times respectively.
1) Default Calibration
Select Default and the magnification and you can measure the image by Line, Perimeter or
Area. When you select a desired area, the measurement result will be displayed nearby.
Figure 5-21
2) Manual Calibration
To Next Page
Loading...
