Chapter 24
| Multicast Filtering Commands
MLD (Layer 3)
– 788 –
show ipv6 mld
interface
This command shows multicast information for the specified interface.
Syntax
show ipv6 mld interface [interface]
interface
vlan vlan-id - VLAN ID. (Range: 1-4094)
Default Setting
None
Command Mode
Privileged Exec
Example
The following example shows the MLD configuration for VLAN 1, as well as the
device currently serving as the MLD querier for active multicast services on this
interface.
Console#show ipv6 mld interface vlan 1
VLAN 1 : Up
MLD : Enabled
MLD Version : 2
MLD Proxy : Disabled
MLD Unsolicited Report Interval : 400 sec
Robustness Variable : 2
Query Interval : 125 sec
Query Max Response Time : 10
Last Member Query Interval : 1
Expire The time remaining before this entry will be aged out. (The default is
260 seconds.)
This field displays “stopped” if the Group Mode is INCLUDE.
Group Mode In Include mode, reception of packets sent to the specified multicast
address is requested only from those IP source addresses listed in the
source-list parameter. In Exclude mode, reception of packets sent to the
given multicast address is requested from all IP source addresses except
for those listed in the source-list parameter, and where the source timer
status has expired. Note that Exclude mode does not apply to SSM
addresses.
Last Reporter The IP address of the source of the last membership report received for
this multicast group address on this interface.
Group Source List A list of zero or more IP unicast addresses from which multicast
reception is desired or not desired, depending on the filter mode.
Source Address The address of one of the multicast servers transmitting traffic to the
specified group.
Fwd Indicates whether or not traffic will be forwarded from the multicast
source.
Table 157: show ipv6 mld groups - display description (Continued)
Field Description
To Next Page
Loading...
Need help?
General