Chapter 13
| Power over Ethernet Commands
– 470 –
show power inline
status
This command displays the current power status for all ports or for specific ports.
Syntax
show power inline status [interface]
interface
ethernet
unit - Unit identifier. (Range: 1-8)
port - Port number. (ECS4620-28P/52P/52P-2AC ports 1-24/48)
Command Mode
Privileged Exec
Example
Console#show power inline status
Unit: 1
Compatible mode : Enabled
Max Used
Interface Admin Oper Power Power Priority
--------- -------- ---- -------- -------- --------
Eth 1/ 1 Enabled Off 30000 mW 0 mW Low
Eth 1/ 2 Enabled Off 30000 mW 0 mW Low
Eth 1/ 3 Enabled Off 30000 mW 7505 mW Low
Eth 1/ 4 Enabled Off 30000 mW 0 mW Low
Eth 1/ 5 Enabled Off 30000 mW 0 mW Low
Eth 1/ 6 Enabled Off 30000 mW 0 mW Low
Eth 1/ 7 Enabled Off 15400 mW 8597 mW Low
Eth 1/ 8 Enabled Off 15400 mW 0 mW Low
Eth 1/ 9 Enabled Off 15400 mW 0 mW Low
Eth 1/10 Enabled Off 15400 mW 0 mW Low
Eth 1/11 Enabled Off 15400 mW 0 mW Low
Eth 1/12 Enabled Off 15400 mW 0 mW Low
.
.
.
Table 82: show power inline status - display description
Field Description
Admin The power mode set on the port (see power inline)
Oper The current operating power status (displays on or off)
Power (mWatt) The maximum power allocated to this port (see power inline maximum
allocation)
Power (used) The current power consumption on the port in milliwatts
Priority The port’s power priority setting (see power inline priority)
To Next Page
Loading...
Need help?
General