Edge-Core ECS4620-28P User Manual

Chapter 11 | Interface Commands
Interface Configuration
– 440 –
Example
This example shows the configuration setting for port 1.
Console#show interfaces switchport ethernet 1/1
Information of Eth 1/1
Broadcast Threshold : Enabled, 500 packets/second
Multicast Threshold : Disabled
Unknown Unicast Threshold : Disabled
LACP Status : Disabled
Ingress Rate Limit : Disabled, 1000M bits per second
Egress Rate Limit : Disabled, 1000M bits per second
VLAN Membership Mode : Hybrid
Ingress Rule : Disabled
Acceptable Frame Type : All frames
Native VLAN : 1
Priority for Untagged Traffic : 0
GVRP Status : Disabled
Allowed VLAN : 1(u)
Forbidden VLAN :
802.1Q Tunnel Status : Disabled
802.1Q Tunnel Mode : Normal
802.1Q Tunnel TPID : 8100 (Hex)
Layer 2 Protocol Tunnel : None
Console#
Table 75: show interfaces switchport - display description
Field Description
Broadcast
Threshold
Shows if broadcast storm suppression is enabled or disabled; if enabled it also
shows the threshold level (page 485).
Multicast Threshold Shows if multicast storm suppression is enabled or disabled; if enabled it also
shows the threshold level (page 485).
Unknown Unicast
Threshold
Shows if unknown unicast storm suppression is enabled or disabled; if enabled
it also shows the threshold level (page 485).
LACP Status Shows if Link Aggregation Control Protocol has been enabled or disabled
(page 457).
Ingress/Egress Rate
Limit
Shows if rate limiting is enabled, and the current rate limit (page 1023).
VLAN Membership
Mode
Indicates membership mode as Trunk or Hybrid (page 598).
Ingress Rule Shows if ingress filtering is enabled or disabled (page 597).
Acceptable Frame
Type
Shows if acceptable VLAN frames include all types or tagged frames only
(page 595).
Native VLAN Indicates the default Port VLAN ID (page 598).
Priority for
Untagged Traffic
Indicates the default priority for untagged frames (page 634).
GVRP Status Shows if GARP VLAN Registration Protocol is enabled or disabled (page 588).
Allowed VLAN Shows the VLANs this interface has joined, where “(u)” indicates untagged and
“(t)” indicates tagged (page 595).
Forbidden VLAN Shows the VLANs this interface can not dynamically join via GVRP (page 588).

Edge-Core ECS4620-28P Specifications

General

Brand	Edge-Core
Model	ECS4620-28P
Category	Switch
Language	English