Chapter 4
| System Management Commands
SMTP Alerts
– 172 –
SMTP Alerts
These commands configure SMTP event handling, and forwarding of alert
messages to the specified SMTP servers and email recipients.
logging sendmail This command enables SMTP event handling. Use the no form to disable this
function.
Syntax
[no] logging sendmail
Default Setting
Enabled
Command Mode
Global Configuration
Example
Console(config)#logging sendmail
Console(config)#
logging sendmail
destination-email
This command specifies the email recipients of alert messages. Use the no form to
remove a recipient.
Syntax
[no] logging sendmail destination-email email-address
email-address - The source email address used in alert messages.
(Range: 1-41 characters)
Table 23: Event Logging Commands
Command Function Mode
logging sendmail Enables SMTP event handling GC
logging sendmail
destination-email
Email recipients of alert messages GC
logging sendmail host SMTP servers to receive alert messages GC
logging sendmail level Severity threshold used to trigger alert messages GC
logging sendmail source-
email
Email address used for “From” field of alert messages GC
show logging sendmail Displays SMTP event handler settings NE, PE
To Next Page
Loading...
Need help?
General