– 467 –
13 Power over Ethernet Commands
The commands in this group control the power that can be delivered to attached
PoE devices through the RJ-45 ports 1-24/48 on the ECS4620-28P/52P/52P-2AC.
The switch’s power management enables total switch power and individual port
power to be controlled within a configured power budget. Port power can be
automatically turned on and off for connected devices, and a per-port power
priority can be set so that the switch never exceeds its allocated power budget.
When a device is connected to a switch port, its power requirements are detected
by the switch before power is supplied. If the power required by a device exceeds
the power budget of the port or the whole switch, power is not supplied.
power inline This command instructs the switch to automatically detect if a PoE-compliant
device is connected to the specified port, and turn power on or off accordingly. Use
the no form to turn off power for a port.
Syntax
[no] power inline
Default Setting
Detection is enabled for PoE-compliant devices.
Command Mode
Interface Configuration (ECS4620-28P/52P/52P-2AC Ethernet ports 1-24/48)
Command Usage
â—† The switch only provides power to the Gigabit Ethernet RJ-45 ports.
Table 81: PoE Commands
Command Function Mode
power inline Turns power on and off for specific ports IC
power inline maximum
allocation
Sets the maximum power available to specific switch ports IC
power inline priority Sets the priority for power supplied to specific ports IC
show power inline status Displays the current status of power management on specific
ports or all ports
PE
show power mainpower Displays the current status of power management for switch PE