User Manual
Enterprise Access Point
56
6.3 System Upgrade
There are two methods of firmware upgrade: via the WMI or via a TFTP server. The administrator can
obtain the latest firmware from the Edgecore Support Team. To upgrade the firmware, click “Choose
File” to select the new firmware file you downloaded onto your PC and then click “Upload” to execute
the process. To upgrade by TFTP, enter the designated IP address, Port, and File Name, then click
“Apply”. Please restart the system after upgrading the firmware.
• It is recommended to check the firmware version number before proceeding
further. Please make sure you have the correct firmware file.
• Firmware upgrade may sometimes result in the loss of data. Please ensure that all
necessary settings are written down before upgrading the firmware.
• During firmware upgrade, please do not turn off the power. This may permanently
damage the system.
• Upgrade by TFTP may be limited on selected AP models.
6.4 Reboot
Click Reboot to restart the AP safely. The process takes approximately three minutes. The System
Overview page will appear after a successful reboot. Note: in some cases, it is necessary to reboot the
AP to ensure that parameter changes are submitted.
To Next Page
Loading...
