User Manual
Enterprise Access Point
59
6.7 Discovery Utility
The network administrators need to access or change some information without entering AP interface,
such as forget the IP address of the AP, forget the admin’s password, or configure the IP address of the
AP.
All they need to do is connect Edgecore AP within the same Layer 2 from the ports of the current
system, and press the “Search” button to execute the IP Discovery Utilities. The scanning results would
be devices’ corresponding IP address, MAC address, Model, System Name, SSID (each VAP), VLAN ID.
The LAN ports of devices could connect through switch to other devices (APs).
Scan Now: Click this button to start the discovery process, and the results will be displayed in the
Discovery List table.
Search: Enter a keyword to search for the particular AP(s).
Change: This allows administrators to change the particular AP’s settings, including IP address, Netmask,
Gateway, Primary DNS Server, Username, and Password.
To Next Page
Loading...
Need help?
General
