5-4 5.0 TROUBLESHOOTING
4125 SIDE SCAN SONAR SYSTEM 0004823_REV_F
Figure 5-4: Removing the Phillips Head Screws from the Electronics Bottle
6. Remove the electronics chassis from the electronics bottle by pulling the electronics bottle
connector end cap straight out as shown in FIGURE 5-4.
NOTE: The use of locking sleeves attached to the connectors will aid in
removal. For bottles which are difficult to remove, contact EDGETECH
CUSTOMER SERVICE.
7. Lay the electronics chassis on a clean, flat surface.
8. If it is desired to reconnect the tow cable connector for troubleshooting and test purposes, place
the electronics chassis alongside the transducer array of the towfish and reconnect the
connectors.
To Next Page
Loading...
