15. Press F10 to save the new configuration.
16. Reset the print server to have the changes take
effect.
NOTE: The print server may require up to a minute
after power-up to log into a NetWare Directory Services
context because of the large number of calculations NDS
security requires.
Your print server should now be ready for use by
workstation users. You should be able to redirect printing to
your print server using a CAPTURE command.
5.3.2.2 Configuring as Remote Printer Mode
This remote printer feature is not available for the
10/100Mbps 3-port models. Make sure that you have created
the NetWare print server with Type Remote using
PCONSOLE utility before you configure the print server. For
more detailed information about PCONSOLE, please refer to
NetWare‘s manual. You can set up the NetWare print server,
print queue and printer objects by following the steps below:
1. Run the NetWare
PCONSOLE
program.
2. Change the current context, if necessary, using the
Change Context
menu selection.
To Next Page
Loading...
