Edirol PC-80 - System Settings - Speaker Control; Speaker On;Off Setting Procedure

87
System settings for the PC-80
fig.util*
1
Simultaneously press the MIDI CH button and PGM CHANGE button,
and hold them down for a few moments.
The PC-80’s display will indicate “UTL,” and you will be in Utility mode.
fig.sy0
2
Press the [AUDIO SYSTEM] key on the keyboard.
“AS0” appears (blinking) in the display.
3
Use the VALUE encoder or the [2] key of the keyboard to choose “ AS2 .”
fig.enter
4
Press the ENTER button.
* If you press any other button without pressing the ENTER button, the setting will be
cancelled.
5
Use the VALUE encoder or press the [0] or [1] key of the keyboard to switch
the PC-80’s internal speaker output on or off.
The display will indicate either “ON” or “OFF.”
6
Press the ENTER button.
SPEAKER ON/OFF
Key Setting
0 OFF
1 ON
Speaker On/Off Setting
You can change the SPEAKER ON/OFF setting by holding down [DIRECT MONITOR] or
[OCTAVE+] while you turn on the power.
fig.speaker2
SPEAKER ON
Turn on the power while holding down [DIRECT
MONITOR].
SPEAKER OFF Turn on the power while holding down [OCTAVE+].
PC-80_e.book 87 ページ ２００５年１１月１０日 木曜日 午前１１時３４分