Edirol PC-80 - System Settings - Factory Reset; Performing Factory Reset

97
System settings for the PC-80
fig.util*
1
Simultaneously press the MIDI CH button and PGM CHANGE button,
and hold them down for a few moments.
The PC-80’s display will indicate “UTL,” and you will be in Utility mode.
fig.sy0
2
Press the [SYSTEM] key on the keyboard.
“SY0” appears (blinking) in the display.
3
Use the VALUE encoder or the [6] key of the keyboard to choose “ SY6 .”
fig.enter
4
Press the ENTER button.
* If you press any other button without pressing the ENTER button, the setting will be
cancelled.
fig.rst
5
The display will indicate “RST.”
fig.yes
6
Press the ENTER button.
The display will blink “YES.”
7
Press the ENTER button.
FACTORY RESET
PC-80_e.book 97 ページ ２００５年１１月１０日 木曜日 午前１１時３４分