EKF SC3-LARGO - Installing the Board

To Next Page

To Previous Page

User Guide • SC3-LARGO • CompactPCI

Serial CPU Board • Intel

Core

5xxx Processor

Installing the Board

Warning

This procedure should be done only by qualified technical personnel. Disconnect the system from its

power source before doing the procedures described here. Failure to disconnect power, or

telecommunication links before you open the system or perform any procedures can result in personal

injury or equipment damage.

Typically you will perform the following steps:

C Switch off the system, remove the AC power cord

C Attach your antistatic wrist strap to a metallic part of the system

C Remove the board packaging, be sure to touch the board only at the front panel

C Identify the related CompactPCI

slot (peripheral slot for I/O boards, system slot for CPU

boards, with the system slot typically most right or most left to the backplane)

C Insert card carefully (be sure not to damage components mounted on the bottom side of the

board by scratching neighboured front panels)

C A card with onboard connectors requires attachment of associated cabling now

C Lock the ejector lever, fix screws at the front panel (top/bottom)

C Retain original packaging in case of return