Safety warnings
ELCA
18
The Manufacturer of the Machine, the Installer, the
Owner, the User and the Maintenance Technician need to
make sure that these delays can never lead to a situation
of danger in the specic application.
7.4 Unintended activations of the commands
The User should operate the Radio Remote Control correctly, following
the use and maintenance instructions.
If the Unit is used correctly, accidental contact with parts
of the body of the User or with foreign objects, does not
cause the unintended operation of the actuators.
Any action is carried out on the Transmitting Unit, or part
of it, in order to operate the actuators in a way other
than that indicated in the Manual is an incorrect use of
the Radio Remote Control and cause serious damage to
Persons and/or property.
The User should use the Radio Remote Control in
compliance with the use and maintenance instructions
and all applicable Laws, Regulations and Standards, also
local, in the country where the Radio Remote Control
and the Machine are used, always maintaining control of
the Radio Remote Control and the position of use just as
described in the specic part of the Transmitting Unit.
The Manufacturer of Machine and/or the Installer
should assess and eventually adopt additional protective
measures for the actuators (for example: two-hand
controls, "dead-man" function) in the case where
particular locations, equipment and working modes can
create situations of risk and in the case this is required
by the applicable Laws, Regulations and Standards in
the country where the Radio Remote Control and the
Machine are used.
It is possible that a command is activated or deactivated
because of electrical and/or mechanical faults, which
can affect the Radio Remote Control and/or the Machine.
The Manufacturer of the Machine and/or the Installer
of the Radio Remote Control should carefully assess
what the consequences of this malfunction are. If the
risk analysis requires it, protective measures should
be prepared that avert, reduce or signal situations of
potential risk.
If a command is activated and/or deactivated because of electrical
and/or mechanical faults:
- press the STOP button to put the machine in a safe state,
- disable the Radio Remote Control and cease using the "Machine+Radio
Remote Control" system until the problem is solved by means of
the required technical intervention.
To Next Page
Loading...
