ELCA E1 Series - Classification of the Controls

Radio Remote Control of the Range E1
ELCA
24
8.7 Classication of the controls
This paragraph describes the classication of the controls in the Radio
Remote Control: this information is useful during installation and
maintenance.
Type of control: analogue or digital
The commands sent by the Transmitting Unit can be either analogue
or digital.
An analogue command generates a proportional output depending on
the position of the relative actuator.
A digital command switches the state of the relative output according
to the position of the corresponding output. This state can be on or off.
Name of the commands
All the commands sent by the Transmitting Unit are identied with
initials.
These initials are reported in the Position of the controls and in the
Connection diagram to be used during installation.
These documents clarify the correspondence between the commands
sent by the Transmitting Unit and those available in the Receiving Unit.