ENG
ELCA
General operating instructions
37
11.8 Switching off of the Transmitting Unit
If you have to switch off the Transmitting Unit just press the STOP
button (see paragraph 11.2).
If the Radio Remote Control is not used to control the
Machine, the Transmitting Unit should be switched off.
Switch off is necessary also when the work is interrupted
also for brief periods.
Do not leave the load suspended or the Machine in a
dangerous condition (also when charging the Unit or
changing the battery).
FAILURE TO COMPLY WITH THESE INSTRUCTION SCAN
CAUSE SERIOUS INJURIES OR DEATH AND/OR DAMAGE
TO PROPERTY.
11.9 "Customised Signals" function
It is possible to customise the information for certain situations and
movements of the Machine, helping the User top assess the operating
situation of the Machine.
The signals depend on the settings chosen by the Installer for the Radio
Remote Control on the Machine.
The signals occur through the coming on of the LED available on the
Transmitting Unit during normal use of the Radio Remote Control.
The customised LED signals can never be considered nor
used as a safety signal or for legal metrology.
If the green LED repeats three ashes and a pause, there is no
information and/or signals of the "Data Feedback" function. in
this case, bring the Transmitting Unit closer to the Receiving
Unit until the green LED starts ashing slowly.
11.10 Replacing the Transmitting Unit
If the Transmitting Unit is no longer usable, it can be replaced with
a new identical Transmitting Unit, which can be requested from Elca.
The replacement operations should only be carried out by
qualied personnel and only in the maintenance phase with
the machine stopped in safety conditions.
To Next Page
Loading...