Guide to solving problems
ELCA
46
14 Guide to solving problems
If the Radio Remote Control is not working correctly, carry out the
following preliminary controls:
- move all the Transmitting Units in the work area away from the Elca
Transmitting Unit used, in order to avoid possible radio disturbance
and interference;
- move the Elca Transmitting Unit closer to the corresponding Elca
Receiving Unit, in order to avoid possible radio disturbance and
interference, positioning it always in a safe place with a complete
view of the Machine, the work area and the load, if present;
- check to see if the problem is with the Radio Remote Control or
the Machine: to this end, it is necessary to do a control test of
the Machine using a different control station to the Radio Remote
Control, if present. If the problem persists after this test, you need
to work on the Machine following the Manufacturer's instructions.
Otherwise the problem is with the Elca Radio Remote Control, so
further controls will be needed.
14.1 Solutions in the event of malfunctions
The table below indicates the malfunctions that can be encountered when
the LED in the Transmitting Unit come on and the relative remedies. If
the problem persists after implementing the solution indicated, contact
the assistance service of the Machine Manufacturer.
SIGNAL POSSIBLE CAUSE SUGGESTED REMEDY
The LED does not
switch on.
The battery is low. Recharge the battery.
The LED is red and
then green for 3
seconds, then switches
off.
The ID code has not
been acquired.
Carry out the coupling
procedure.
The green LED is
on and steady for
5 seconds and then
the red LED is on for
1 second, then the
Transmitting Unit
switches off.
The access sequence
has not been entered.
Insert the access
sequence of the
Transmitting Unit.
The red LED is on
steady for 1 second,
then the Transmitting
Unit switches off.
The access sequence is
incorrect.
Insert the correct
access sequence of the
Transmitting Unit.
To Next Page
Loading...