ELCA E1 Series - Page 47

ENG
ELCA
Guide to solving problems
47
SIGNAL POSSIBLE CAUSE SUGGESTED REMEDY
The green LED is on
steady for 10 seconds
then ashes twice
every 2 seconds.
The Radio Remote
Control, is outside the
operating range.
Make sure that the
operating distance
is within the work
range and that the
Radio Remote Control,
has been installed
correctly.
The Receiving unit is
off or not working.
Supply power to
the Receiving Unit.
Remember that
switching off the
Receiving Unit
also causes the
Transmitting Unit to
switch off.
The green LED is
ashing and then the
LED turns red and on
steady for 10 seconds,
then the Transmitting
Unit switches off.
The Transmitting Unit
is not coupled with any
Receiving Unit.
Carry out the coupling
procedure for replacing
the Transmitting Unit.
The red LED is on and
steady.
The STOP button is
pressed.
Release the STOP
button.
SIGNAL POSSIBLE CAUSE SUGGESTED REMEDY
The green LED blinks
rapidly.
The Radio Remote
Control is subject to
radio disturbance.
Ensure there are
no other similar
systems or sources of
interference such as
radio relay systems or
transmitters. Switch
off the Transmitting
Unit and then switch it
back on.
The green LED is on
and steady, then turns
red and blinks twice
every 2 seconds.
The Receiving Unit is
in error.
Switch off the
Transmitting Unit and
then switch it back on.
The system has
not been installed
correctly.
Check that the system
has been installed
correctly (for example:
the position of the
Receiving Unit, the
presence of metal
obstacles, etc.).
The green LED blinks
rapidly.
There is radio
disturbance.
Ensure there are
no other similar
systems or sources of
interference such as
radio relay systems or
transmitters. Switch
off the Transmitting
Unit and then switch it
back on.