ELCA E1 Series - 1 Use and Maintenance Manual; Structure; Definitions

ENG
ELCA
Use and Maintenance Manual
9
1 Use and Maintenance Manual
1.1 Structure
The Instruction Manual for use and maintenance consists of two parts:
together they constitute the Elca Radio Remote Control of the series
E1. The Manual should be read, understood and applied by the Owner
of the Radio Remote Control, by the User and by all those who, for
whatever reason, operate the Radio Remote Control or the Machine
on which it is installed.
This part (called Part 1) deals with the Transmitting Unit and the
charging system. Part 2 (to which reference is made) deals with the
Receiving Unit.
The contents of the Instruction manual for use and maintenance is
supplemented by the following documents:
- “Arrangement of Controls” that contains the conguration of the
Transmitting Unit and the names of the commands sent to the
Receiving Unit;
- “Connection diagram” that indicates the correspondence of the
commands sent by the Transmitting Unit and those available in
the Receiving Unit .
The Instruction manual for use and maintenance is an integral part
of the Elca Radio Remote Control and therefore of the Machine that is
equipped with the Radio Remote Control. It is the responsibility of the
Manufacturer of the Machine or the system on which the Radio Remote
Control is installed to ensure that the Instruction Manual is inserted in
the instruction manual of the Machine.
Further information on the operation of the radio remote control system,
particularly if made to the customer's own specications, can be found
in the documents attached to the manual that should be considered as
an integral part of the Manual itself.
1.2 Denitions
Please contact Elca if any instructions, symbols, warnings or
images are unclear or incomprehensible or if you have any
doubts or questions.
The meanings of the terms in the entire Manual, including all its parts,
are shown below:
- Unit: the individual units, transmitting and receiving, that make
up the Elca Radio Remote Control.
- Radio Remote Control: wireless control system (CCS: Cableless
Control System) composed of a Transmitting unit and a Receiving
unit that communicate with each other via radio connection.
- Transmitting unit: portable component (remote station) through
which the user interfaces with the Radio Remote Control.
- Receiving unit: component xed stably to the Machine (base
station) that constitutes an interface between the Radio Remote
Control and the other parts of the machine.
- Machine:the machine, as dened by Directive 2006/42/CE and
by other local regulations, and every other device, machinery,
equipment, system, application, etc., on which the Elca Radio
Remote Control is installed or that is controlled by it.
- Manufacturer: the entity that designs and/or constructs a Machine
and that decides to install a Radio Remote Control in order to
operate the Machine.
- Installer: the entity, specialised technician, that plans and/or
carries out the installation of the Elca Radio Remote Control on a
Machine in order to operate its controls.
- User: the entity that materially uses the Elca Radio Remote Control
as a device for operating the controls of a Machine.