EasyManua.ls Logo

ELCA E1 Series - 12 Charging System of the Transmitting Unit; Instructions for Use

Default Icon
50 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
ENG
ELCA
Charging system of the Transmitting Unit
39
12 Charging system of the Transmitting Unit
Inside the Transmitting Unit there is a rechargeable battery that cannot
be removed from the Radio Remote Control.
To charge the battery, the charging device (Elca-Clip) supplied with the
Elca Radio Remote Control must be used.
The Transmitting Unit should be charged in a place where the temperature
is between 0°C and 40°C; this will provide the best performance in
terms of battery capacity and useful life.
12.1 Instructions for use
The charging system is for professional use, therefore it
can only be used by competent personnel or by suitably
trained persons.
The charging system cannot be used by a Person with
limited physical, sensory and mental abilities and by
children.
The charging system should not be used with wet or
damp hands or feet. The use of the charging system does
not require any special tools. In any case, do not for any
reason use objects and/or tools that are not insulated
since they could conduct electricity.
Before charging the Transmitting Unit always make sure
it is undamaged and the contacts are clean both on the
Unit and also on the charger.
If cleaning is required, the Transmitting Unit should be
switched off and/or the charging system disconnected
from the power supply.
Use a damp cloth with a cleaner for the electric contacts
or a non-abrasive brush.
Protect the charging system from dust and material like
lime, sand, concrete or other substances.
Be very careful when using the charging system, since it
can be a source of re, overheating and other dangers.

Table of Contents