ELCA E1 Series - 13 Maintenance; Maintenance of the Radio Remote Control - General Instructions

Maintenance
ELCA
42
13 Maintenance
13.1 Maintenance of the Radio Remote Control - general
instructions
It is the responsibility of the Maintenance Technician:
- keep the Transmitting Unit safe so that it cannot be used by
unauthorised or unqualied personnel;
- use the Machine on which the Elca Radio Remote Control is installed
only in safe conditions and only if it is possible to get a good view
of the working area of the Machine;
- use the Machine on which the Elca Radio Remote Control is installed
only in accordance with the measures and instructions provided by
the Manufacturer of the Machine and in compliance all applicable
Laws, Regulations and Standards, also local;
- immediately notify superiors and/or managers of the workplace
and/or the Machine of any faults, subsidence, deterioration of
any other fault that could cause the Radio Remote Control and/
or the Machine to malfunction or that could injure Persons and/or
damage property;
- respect all the instructions and warnings provided by the
Manufacturer of the Machine and/or the Installer;
- respect all the instructions and warnings provided by the person
responsible for starting up the Machine for work;
- respect all the instructions and warnings contained in the Manual
of the Radio Remote Control;
- all applicable Laws, Regulations and Standards, also local, must
be respected;
- use the Radio Remote Control only as described in this Manual, as
explained in all the warnings and instructions provided by Elca and
in any event not contrary to all the applicable Laws, Regulations
and Standards, also local;
All set up, control and maintenance operations of the Radio Remote
Control must be recorded. The person responsible for the Maintenance
of the Machine should record them.
Before carrying out any maintenance, it is necessary that:
- the Receiving Unit is NOT powered;
- the Transmitting Unit is off;
- the STOP button is pressed.
In the event of a malfunction the Transmitting Unit should
be switched off and the Receiving Unit disconnected from
the power supply. The Radio Remote Control must remain
disabled until the problem is solved with the necessary
technical interventions.
After each maintenance operation, it is necessary to:
- check that the gasket is undamaged and correctly
positioned;
- check that the parts of the casing are properly
connected so that they overlap;
- screw in the screws.
After each maintenance operation, always check that
all the commands sent by the Transmitting Unit activate
only the movements expected.