General operating instructions
ELCA
36
11.4 Activating the controls
Once the Radio Remote Control has been started it is possible to start
the buttons for the controls of the Machine.
It is the responsibility of the Installer and/or the Manufacturer of the
Machine to choose the functions and the symbols of the buttons of the
Transmitting Unit and it is always their duty to provide these instructions
with the Machine so that the User is well informed on this matter.
11.5 Interruption of the radio link
If for any reason the radio link is incorrect or interrupted, use the
automatic stop function (see paragraph 7.3).
11.6 Automatic switching off of the Transmitting Unit
If the Transmitting Unit stays on for a pre-set time without receiving
any movement commands, the automatic switch-off intervenes.
The automatic switch off intervenes even when the Unit battery is low.
The automatic switch-off is indicated on the Transmitting Unit by the
LED; 30 seconds before the switch off, the LED ashes red and green
alternately.
Pressing any button on the Transmitting Unit the pre-set auto switch-
off time is reset.
To start the Radio Remote Control see paragraph 11.3.1Start up using
a PIN code.
It remains the responsibility of the Manufacturer of the Machine
or the Installer to decide the auto switch-off time or its eventual
modication.
This setting should be established based on the operation and
performance of the Machine.
11.7 Charging the Transmitting Unit
The table below indicates the signals regarding the charge state of the
Transmitting Unit.
SIGNAL MEANING
The green LED ashes
slowly ( 1 ash/second).
The Transmitting Unit is charged.
Red LED blinks
slowly (1 blink/second).
The Transmitting Unit has a low
battery
(1 hour of run time).
The red LED ashes
rapidly.
The Transmitting Unit has a low
battery
(5 minutes of run time).
To charge the Transmitting Unit see chapter 12.
To Next Page
Loading...