ELCA E1 Series - 9 Instructions for the User; Use of the Radio Remote Control and Operating Conditions; General Warnings for the User

ENG
ELCA
Instructions for the User
25
9 Instructions for the User
All the instructions and warnings of the Elca Radio
Remote Control in this Manual should be read and
understood. Failure to understand or follow them can
cause serious injuries or death or damage to property.
9.1 Use of the Radio Remote Control and operating
conditions
For the correct use of the Radio Remote Control all the warnings and
instructions in the Manual must be respected. It is also necessary to
comply with what is reported in the documentation of the Radio Remote
Control and the Machine on which the Radio Remote Control is installed.
It is necessary to comply with all workplace safety and accident
prevention regulations.
Finally, all applicable Laws, Regulations and Standards, also local,
must be respected.
Below are some examples of behaviours to be avoided in using the
Radio Remote Control.
These examples are given purely by way of example and do not cover
all possible incorrect uses of the Radio Remote Control.
It is the responsibility of the Manufacturer of the machine and the
User to evaluate and establish any measures for avoiding the possible
incorrect use of the Radio Remote Control or the Machine.
NO
NO
9.2 General warnings for the User
The User should:
- check that the units of the Radio Remote Control are undamaged
and operational;
- keep the Transmitting Unit safe so that it cannot be used by
unauthorised or unqualied personnel;
- check that the STOP button is working correctly;
- check that the controls of the Machine are working correctly;
- immediately notify superiors and/or managers of the workplace
and/or the Machine of any faults, subsidence, deterioration of
any other fault that could cause the Radio Remote Control and/
or the Machine to malfunction or that could injure Persons and/or
damage property;
- not the Radio Remote Control if it is damaged or if the controls are
not working correctly;
- use the Machine on which the Elca Radio Remote Control is installed
only in safe conditions and only if it is possible to get a good view
of the working area of the Machine;