ENG
ELCA
Instructions for the User
27
9.3 Environmental conditions of use
The environmental conditions of use of the Elca Radio Remote Control
are the following:
Unit Temperature
Transmitting Unit from -25°C to +55°C
9.4 Warnings before starting work
Before starting work with the Radio Remote Control the
User should:
- get in a position that allows both direct control of the
Machine and also the movement of the load;
- get in a safe position with respect to the load, the
Machine and any other activity, operation of the
workplace;
- get in a work position where you will not lose your
balance or stumble;
- check that the STOP button mechanism is working
correctly;
- use the Transmitting Unit only for its intended
purpose or operating requirements;
- learn the correspondence between the actuators and
the operations of the Machine.
The User should not:
- switch on or use the Radio Remote Control in enclosed
spaces or places with poor visibility;
- use the Radio Remote Control if it is outside the
operating range.
Failure to comply with the points above can lead to
a connection between the Units of the Radio Remote
Control that is not optimal, with the risk that the Machine
carries out undesired commands.
The symbols on the Transmitting Unit panel have been
chosen by the Manufacturer of the Machine and/or the
Installer based on the use and purpose of the Machine.
9.5 Warnings during normal use
During normal use the User should:
- pay attention to the work area and any dangerous
situations present;
- visually check all the movements of the Machine
and the load;
- stay within the operating range of the Radio Remote
Control;
- pay attention to the visual and acoustic signals of
the Radio Remote Control;
- use the Radio Remote Control to move the Machine
safely, to avoid creating dangerous situations for
Persons and/or property;
- switch off the Transmitting Unit and disconnect the
power supply to the Receiving Unit in the event of
a malfunction;
To Next Page
Loading...