ELCA E1 Series - 11 General Operating Instructions; START Command; STOP Button

General operating instructions
ELCA
34
11 General operating instructions
11.1 START command
The START button is used for:
- switching on the Transmitting Unit when it is off;
- activating the START function and the ALARM function when the
Receiving Unit is active;
- displaying the charge status during the charging phase (see
paragraph 12.5).
This command is on the selector [C] of the Transmitting Unit dedicated
to this purpose.
C
3
4
11.2 STOP button
The STOP button stops the Machine and switches off the Transmitting
Unit.
STOP
3
4
To restart working after the STOP button was pressed, proceed as
follows:
- check that the operating conditions are safe;
- turn the STOP button in the direction indicated to disengage it;
- carry out the procedure for starting the Radio Remote Control (see
paragraph 11.3).
if a dangerous situation arises press the STOP button to
immediately stop the Machine.
It is necessary to check that the Manufacturer of the
Machine and/or the Installer provide suitable instructions
and warnings in relation to any risks that derive from
the stoppage of the Machine. These risks could, for
example, come from inertial movements or from the
swinging of the load.