ELCA E1 Series - Technical Data; The Position of the Controls and Connection Diagram; Transmitting Unit Data Plate

ENG
ELCA
Description of the Transmitting Unit
31
10.1 Technical data
Radio transceiver module MT32EL
Antenna incorporated
Power supply Li-ion 3.7 V battery
Current draw <45 mA
Absorbed power <0.15 W
RF effective radiated power <10 mW ERP
Run time with fully charged battery
at 20 °C (emissions power 10mW)
20 hours
Run time after rst low battery
warning
60 min
Run time after second low battery
warning
5 min
Protection degree IP65
Dimensions 170x74x81 mm
Weight 400 g
10.2 The Position of the controls and Connection
diagram
The documentation supplied with the Radio Remote Control consists of:
- “Arrangement of Controls” that contains the conguration of the
Transmitting Unit and the names of the commands sent to the
Receiving Unit;
- “Connection diagram” that indicates the correspondence of the
commands sent by the Transmitting Unit and those available in
the Receiving Unit .
The Connection diagram should be checked, lled out and signed by
the Installer who is responsible for carrying out the wiring correctly.
The Position of the controls and the Connection diagram should always
remain attached to this Manual: if you have to use one or more of
these documents for administrative purposes (controls, tests, etc.) a
copy should be made.
The wiring of the outputs of the Receiving Unit should
always correspond to what is indicated in the Position
of the controls and the Connection diagram.
10.3 Transmitting Unit data plate
There is just one Data plate on the Transmitting Unit AT E1-VETTA.
Its position and the information contained in it can be found in the
table below.