Radio Remote Control of the Range E1
ELCA
22
Do not remove the data plate on the Units from their position,
since removing it will immediately void the warranty.
If the data plate has been altered or damaged, contact Elca
for a replacement.
8.5 Transportation and/or storage
The Radio Remote Control and all its parts should be transported
and stored according to the following parameters and environmental
conditions:
Operation Temperature
Transportation from -25°C to +55°C
Storage from -25°C to +55°C
The original packaging should be kept for the entire life of the product.
Use the original packaging for transporting and storing the Radio Remote
Control in all the phases of its life, for example before installing and
after its removal.
8.6 Applications
An Elca Radio Remote Control of the E1 range can be used for various
applications: the suitability of the Radio Remote Control for each
different application, especially for safety reasons, should be assessed
by the Manufacturer of the Machine.
The E1 range is most often used on Machines for lifting and moving
materials, objects, and loads in general (for example: overhead travelling
crane, lifting crane, etc.) if permitted by the instructions in this Manual.
An Elca Radio Remote Control should not be installed on
Machines whose application or function is not permitted
by this Manual or by applicable Laws, Regulations and
Standards, also local. THE INSTALLATION OF AN ELCA
RADIO REMOTE CONTROL ON OTHER MACHINES OR FOR
OTHER FUNCTIONS CAN CAUSE SERIOUS INJURY OR
DEATH OR DAMAGE TO PROPERTY.
Elca is not responsible for, and does not accept any
liability for, applications of the Radio Remote Control
in situations where safety conditions are poor or non-
existent.
The Manufacturer of Machine should assess and
eventually adopt additional protective measures for the
actuators (for example: two-hand controls, "dead-man"
function) where particular locations, equipment and
working modes can cause accidental collisions.
To Next Page
Loading...
