ENG
ELCA
Radio Remote Control of the Range E1
23
In addition to the above, a E1 Radio Remote Control
should not be installed:
- On Machines operating in environments that require
explosion-proof equipment, or in all those situations
that carry a risk of explosion.
- On Machines for moving, lifting and transporting
Persons,where the characteristics of the Machine to
be used for these functions and the risks connected
to them and/or connected to the use of a Radio
Remote Control do not allow the Manufacturer of
the Machine to guarantee compliance with all safety
requirements. These requirements should be taken
into consideration when designing and manufacturing
the Machine, also taking into account the use of
the Radio Remote Control. The Manufacturer of the
Machine can allow the installation and use of the
Radio Remote Control on these applications under
its own responsibility.
- On Machines that cause or might cause dangerous
situations in the event of a stoppage due to the loss
of the radio link.
- On Machines that, because of their functions or
characteristics and/or risks connected to their use,
do not allow the use of a Radio Remote Control in
conditions where there are no risks.
- On any type of lifting equipment (for example:
magnets, pliers, suction cups) when the loss of the
radio link or the deactivation of the controls can
cause the release of the load being held, with the
risk of harming Persons and/or damaging property.
The Manufacturer of the Machine can allow the
installation and use of the Radio Remote Control
for these applications under its own responsibility.
- If the applicable legislation in the country where
the Machine is used, and also the local safety
regulations and standards, also with reference to
safety in the workplace, do not allow the use of Radio
Remote Controls for commanding and/or controlling
Machines.
THE INSTALLATION OF AN ELCA REMOTE RADIO CONTROL
ON MACHINES AND IN SITUATIONS DESCRIBED ABOVE
CAN CAUSE SERIOUS INJURIES OR DEATH OR DAMAGE
TO PROPERTY.
To Next Page
Loading...
