ELCA E1 Series - Warnings for after Its Use; Belt

Instructions for the User
ELCA
28
- immediately notify superiors and/or managers of the
workplace and/or the Machine of any malfunctions;
- use the Radio Remote Control only after solving and
problems and/or malfunctions;
- use the Radio Remote Control only with a fully
charged battery;
- end any dangerous operations as soon as possible
in the event of a low battery;
- use any holster, belt for the Transmitting Unit to
prevent the Unit falling or accidentally activating
the actuators.
9.6 Warnings for after its use
Warnings for after its use
- avoid leaving the Machine in dangerous conditions
(for example with a suspended load);
- prevent unauthorised or unsuitable trained persons
from using the Radio Remote Control.
FAILURE TO COMPLY WITH THESE INSTRUCTION SCAN
CAUSE SERIOUS INJURIES OR DEATH AND/OR DAMAGE
TO PROPERTY.
9.7 Belt
The transmitting unit is supplied with a belt.
9.7.1 Pouch belt
Assembly
Before using the Radio Remote Control the User should connect the
belt to the Transmitting Unit, as described in the following procedure.
1 2
3 4