General operating instructions
ELCA
38
The replacement procedure allows you to uniquely connect a new
Transmitting Unit with a Receiving Unit. In compliance with IEC60204-
1 and IEC60204-32 that establish that just one Transmitting Unit can
control the machine at the same time, at the end of this procedure the
Unit that was previously connected to the Receiving Unit is no longer
recognised.
Therefore only the new Transmitting Unit will be able to control the
Machine, taking the place of the previous one.
At the end of the replacement procedure always check that the new
Unit is operating correctly, making sure that all the movements are
executed correctly and in particular the STOP function.
Remove the data plate from the transmitter that is no longer
used and x it to the new one. If this is not possible because
it is lost, destroyed or illegible, contact an ELCA Assistance
Centre for a new one.
To Next Page
Loading...
