06/2016 - Art. Nr. 4200 1041 1103A 19
Installation
Burner head assembly
Burner head assembly
• Remove the cover (3 screws W).
• Check that the O-Ring J1 is in the
correct position in the gas bend.
• Fit the extension rod with the 0-40
scale (supplied loose in the
packaging) for setting the turbulator
(see image).
• The extension rod must be pushed
into the steel sleeve until it makes
contact.
• Insert the combustion components
into the head, tighten the mounting
screw X using an Allen key, then
tighten the lock nut using an open-
ended spanner.
• Thread the ionisation cable IK and the
ignition cables ZK into the grommet R.
• Refit the cover (3 screws W).
To Next Page
Loading...
Need help?
General
