Need help?Do you have a question about the ELIT EuroMaster AutoEv and is the answer not in the manual?
Defines various electrical symbols used in the manual and their meanings.
Explains key terms like WARNING and CAUTION used throughout the manual.
Provides critical safety guidelines to prevent fire, electrical shock, and equipment damage.
Highlights specific precautions to avoid instrument damage or incorrect readings.
Lists the standards and regulations the instrument complies with.
Lists the primary component of the product package.
Details the measuring range, resolution, and accuracy for voltage and frequency.
Specifies parameters for loop resistance and predictive fault current (PFC) measurements.
Provides specifications for measuring line impedance and prospective short-circuit current (PSC).
Details parameters for Residual Current Device (RCD) testing, including trip times and currents.
Outlines parameters for insulation resistance measurement according to EN61557-2.
Details specifications for +200mA continuity and low ohm measurements.
Provides specifications for earth resistance (Re) measurements using different pole methods.
Covers power source, operation duration, measurement categories, and environmental limits.
Identifies and describes the buttons, display, and controls on the front of the instrument.
Details the purpose and connection points for various input terminals on the device.
Highlights safety warnings and product information found on the back of the device.
Explains access to and components within the battery and fuse compartment.
Describes the information present on the bottom label, including measurement ranges.
Explains the different areas and indicators on the instrument's display screen.
Defines the meaning of various symbols shown on the instrument's screen during operation.
Guides users through configuring system settings like date, time, contrast, and backlight.
Details how to measure voltage and determine phase sequence in electrical systems.
Explains procedures for performing loop and Z-line impedance measurements, including connection and interpretation.
Provides step-by-step instructions for various Residual Current Device (RCD) tests, including ramp and trip-time.
Details the process for measuring insulation resistance, including voltage selection and connection methods.
Explains how to perform earth resistance measurements using 2-pole and 3-pole methods.
Guides users through performing low resistance and continuity measurements with relevant specifications.
Describes how to connect and use current clamps and adaptors for measurements.
Explains the operation and status outputs for the EVSE adaptor, including charging current calculation.
Details how to configure and run automated test sequences using the instrument's buttons.
Explains how to manage stored measurement data, including file creation and saving.
Describes how to enable, connect, and utilize Bluetooth Low Energy for data transfer.
General| Brand | ELIT |
|---|---|
| Model | EuroMaster AutoEv |
| Category | Test Equipment |
| Language | English |
To Next Page
