Elmo PX-10E - User Manual

56 pages

Save Page as PDF

To Next Page

PＸ-30E / PX-10E

VISUAL PRESENTER

INSTRUCTION MANUAL

Main Page

Other manuals for Elmo PX-10E

Quick Start Guide86 pages

Questions and Answers

P
Patrick LuceroSep 3, 2025
Why are images on SD card/USB flash drive not displayed on Elmo PX-10E Document Camera?
- C
  carrolljenniferSep 3, 2025
  If images on your SD card or USB flash drive are not displayed on your Elmo Document Camera, remove the SD card/USB flash drive, wait a few seconds, and then reinsert it.
S
Samuel GarciaSep 1, 2025
How to fix the striped image on Elmo PX-10E?
- L
  Logan HendersonSep 1, 2025
  If the image from your Elmo Document Camera appears striped, it may be due to interference fringes between the dots of printed matter and TV scanning lines or CMOS pixels. Changing the shooting range may improve the problem.
D
David BrayAug 31, 2025
How to fix Elmo PX-10E Document Camera when no image is displayed from the USB port?
- D
  Daniel HenryAug 31, 2025
  If no image is displayed from the USB port on your Elmo Document Camera, check the USB mode in the System Setting. If it's set to 'Mass storage (file transfer)', select 'UVC (image output)' instead.
K
Kathleen BrooksAug 29, 2025
Why does Elmo Document Camera not operate with the remote control?
- B
  bjohnsonAug 29, 2025
  If you cannot operate your Elmo Document Camera with the remote control, the battery may be low. Replace it with a new one. Also, make sure you are using the remote control that was supplied with the camera.
A
Alicia PerryAug 27, 2025
What to do if the Elmo PX-10E Document Camera recording stops?
- J
  Jerry WrightAug 28, 2025
  If the recording on your Elmo Document Camera stops, especially when the resolution setting is set to Auto, it might be due to the HDMI cable being disconnected or the monitor being turned off during recording. Set the resolution setting to something other than Auto to continue the recording.
J
Jennifer CraigAug 26, 2025
How to fix out of focus image on Elmo Document Camera?
- R
  Rebecca MaldonadoAug 27, 2025
  If the image from your Elmo Document Camera is out of focus, the document may be too close to the lens. Try moving the document slightly away from the lens.
J
John ThomasAug 25, 2025
Why does Elmo PX-10E Document Camera output image resolution change automatically?
- C
  christopher15Aug 25, 2025
  If the output image resolution of your Elmo Document Camera changes automatically, it's likely because the resolution setting is set to Auto. Change the resolution setting to a fixed value.
M
michaelstevensonAug 22, 2025
What to do if Elmo PX-10E Document Camera image is too dark?
- B
  Bonnie MeyerAug 22, 2025
  If the image from your Elmo Document Camera is too dark, the lighting intensity may be insufficient. Try turning on the LED lighting using the Brightness button on the operating panel, or adjust the Iris.