ELNet LT - 6.3 - Communication Connections; 6.4

To Next Page

To Previous Page

The PARAMETERS ORDER screen appears

Figure 6.1 Parameters Order

Select the requested order that compatible to the driver installed in

your SCADA/HMI

6.3 — Communication Connections

The ELNet LT Energy & Powermeter supports RS485

communication. Connections are provided on the Rear

Panel, (Please refer to section 2.3) and are made by means of the

connectors provided.

6.4 — Communication Settings

To enable the User to connect the ELNet LT

Energy &

Powermeter

to a PC computer for successful communications, the

Communication Setup parameters of both must match; i.e. the port

of the PC and the configuration settings of the Power meter.

Address

Baud Rate

Parity

ELNet LT - 6.3 - Communication Connections; 6.4 - Communication Settings