Elster EK280 - Entering the Battery Capacity

82 Maintenance
CAUTION!
Material damage may arise through improper closing of
the device!
Improper closing of the device may lead to material damage
as a result of cable connections being squashed.
Therefore:
– When closing, ensure that the cable ducts are positioned
correctly.
7.2.2 Entering the battery capacity
The battery capacity must be re-entered after changing a
battery.
When using the device with high communication security
(„High Level Security“, see application manual), the battery
capacity can only be entered with the enSuite software!
 For opening the administrator lock move the cursor to the "Admin" regis-
ter and to the "Cod.A" value (enter administrator key) via the following
path::
Admin.  Device settings  Access  Cod.A
After deliveryof the device, the administrator key for input
via keypad is "00000000".
 Press the ENTER button  The value will start to flash.
 Move the cursor using the arrow keys  or  to the digits and change
these using the arrow keys  or .
 After you have changed all digits, press the ENTER button to confirm
the inputs. The input value can be deleted by pressing the ESC button.
 For entering the battery capacity move the cursor to the "Serv." register
and to the "Bat.C" value (battery capacity) via the following path:
Serv.  Batteries  Bat.C
 Press the ENTER button  The value will start to flash.
 Move the cursor using the arrow keys  or  to the digits and change
these using the arrow keys  or .
When using two size D batteries, the value 13.0 Ah should
be entered for "Bat.C". When using four batteries, the value
26.0 Ah must be entered.
 After you have changed all digits, press the ENTER button to confirm
the inputs. The input value can be deleted by pressing the ESC button.