Faults 85
Works on the electrical appliance may only be carried out by qualified
electricians.
8.1.2 Personal protective equipment
When eliminating faults on the device, the necessary personal protec-
tive equipment for the work must be worn inside the respective plant.
The notices relating to personal protective equipment mounted in the
working area must be followed at all times.
8.1.3 Improper elimination of faults
Risk of injury through improper elimination of faults!
An improper elimination of faults on the device may lead to
serious personal injury or material damage.
Therefore:
– Ensure that there is sufficient assembly space before
commencing works.
– Ensure that the installation location is clean and tidy.
Components that are loosely stacked or lying around can
cause accidents.
– If parts have been removed, ensure that they have been
installed correctly, re-mount all fastenings, and adhere to
tightening torque values for screws.
The following information on possible faults provide indica-
tions as to who is authorized to eliminate the fault.
8.1.4 Behavior in the event of faults
The following generally applies:
1. If works in the danger zone are necessary, the entire plant must be
switched off and protected against an accidental restart.
2. The cause of the fault must be determined.
3. The person responsible for the area in which the fault occurred should
be informed immediately.
4. Depending on the type of fault, the manufacturer may have to be con-
tacted and will then have the fault removed by an authorized specialist,
or will remove the fault themself.
To Next Page
Loading...
