ELTEX POWER CHARGER PC - Page 70

70 BA-en-3041-2008_PC
81 No Diagnostic error:
error in the error
management of the
diagnosis
• Interrupt the supply voltage.
• If this error occurs again, send in the device
for repairs.
82 No Diagnostic error:
invalid state of the
diagnosis
• Interrupt the supply voltage.
• If this error occurs again, send in the device
for repairs.
83 No Diagnostic error: initi-
alization of the dia-
gnosis has failed
• Interrupt the supply voltage.
• If this error occurs again, send in the device
for repairs.
84 Nein Diagnostic error:
ground connection is
faulty
• Interrupt the supply voltage.
• If this error occurs again, send in the device
for repairs.
85 No Diagnostic error:
supply voltage ist
faulty.
• Interrupt and check the
supply voltage.
• If this error occurs again, send in the device
for repairs.
86 No Diagnostic error:
overvoltage
channel 1
charging
• Interrupt the supply voltage.
• Clean the bar.
• Reduce the setpoint value.
• If this error occurs again, send in the device
for repairs.
87 No Diagnostic error:
overvoltage
Channel 2
charging
• Interrupt the supply voltage.
• Clean the bar.
• Reduce the setpoint value.
• If this error occurs again, send in the device
for repairs.
88 No Diagnostic error:
monitoring of the DC
link voltage
• Interrupt the supply voltage.
• If this error occurs again, send in the device
for repairs.
89 No Diagnostic error:
monitoring of the
power stage
• Interrupt the supply voltage.
• If this error occurs again, send in the device
for repairs.
90 No Diagnostic error:
hardware
release
channel 1
charging
• Interrupt the supply voltage.
• Check the release switching.
• If this error occurs again, send in the device
for repairs.
Error
number
Error
clearable
Cause Measure