NORMAL
PROCEDURES
AIRPLANE
F
LIGHT
3-09 ANAC APPROVED
Page 4 code 01 REVISION 15
Copyright © by Embraer. Refer to cover page for details.
--------------------------SHORTLY BEFORE STARTUP-------------------------
Fuel Quantity............................................................CHECK
MCDU ......................................................................SET
− Select the TAKEOFF DATA SET MENU page on the MCDU.
Check if the performance data is consistent with the airplane
configuration and set the data below:
− Thrust Rate Mode (TO-1, TO-2 or TO-3).
− Takeoff Temperature (__ºC).
− ATTCS (ON or OFF).
− REF ECS (ON or OFF).
− REF A/I (OFF, ENG or ALL).
− FLEX T/O (ON or OFF).
− FLEX TEMP (__ºC).
− Select the TAKEOFF page on the MCDU. Set or verify airplane
c
onfiguration, performance data and takeoff speeds.
− Select the LANDING page on the MCDU and set the landing
speeds for the takeoff weight.
Speed Selector Knob ...............................................SET
TOGA Button ...........................................................PRESS
Doors and Windows.................................................CLOSED
Pitch Trim.................................................................SET
Takeoff Briefing........................................................COMPLETED
Red Beacon .............................................................ON
Hydraulic Pump Sys 3A............................................ON
Ground Equipment...................................................AS REQUIRED
Steering Disengage Switch ......................................PRESS