Embraer 175 - Anti-Ice Low Capacity; Anti-Ice Wing Failure; Anti-Ice Engine 1 (2) Failure

ABNORMAL
PROCEDURES
AIRPLANE
F
LIGHT
MANUAL
4-24 ANAC APPROVED
Page 4 code 01 REVISION 15
Copyright © by Embraer. Refer to cover page for details.
AFM
-
1385
AFM
-
1385
ANTI-ICE ENGINE 1 (2) FAILURE
Reset (push out, then in) the affected ice protection engine button.
If the A-I ENG 1 (2) FAIL message persists, set the ice protection
mode selector to on.
Then, if A-I ENG 1 (2) FAIL message still persists, exit and avoid
icing conditions. If also high engine vibration exists, accomplish the
Engine Abnormal Vibration Procedure.
After exiting icing conditions, set the ice protection mode selector to
auto.
ANTI-ICE LOW CAPACITY
Advance the thrust levers.
ANTI-ICE WING FAILURE
Reset (push out, then in) the ice protection wing button.
If
A-I WING FAIL message persists, set the ice protection mode
selector to on.
Then, if A-I WING FAIL message extinguishes, set the ice
protection mode selector to auto after exiting icing conditions.
If A-I WING FAIL message still persists, set the ice protection mode
selector to auto, push the ice protection wing button out and
avoid/exit icing conditions. During landing, if icing conditions are
presented or there is ice accretion, plan a flap 5 landing and
maintain V
REF FLAP 5 ICE
.
CAUTION: MULTIPLY THE FULL FLAPS UNFACTORED LANDING
DISTANCE BY 1.30.
Limit bank angle to 20° maximum.