Embraer 175 - Mfd 1 (2) Fault; Mfd 1 (2) Overheat; Navcom 1 (2) Failure; Navcom 1 (2) Overheat

AIRPLANE
FLIGHT
MANUAL
ABNORMAL
PROCEDURES
ANAC APPROVED 4-18
REVISION 15 code 01 Page 9
Copyright © by Embraer. Refer to cover page for details.
AFM
-
1385
MFD 1 (2) FAULT
Crosscheck the affected MFD display information (System Synoptics,
MAP, TAS, TAT, SAT, TCAS info, WX radar and Terrain Data) with the
opposite side MFD display information. Disregard any non-reliable
information from the affected MFD.
MFD 1 (2) OVERHEAT
Pull the associated circuit breaker and revert the affected MFD if
necessary.
For MFD 1 OVHT, pull the B29 CB.
For MFD 2 OVHT, pull the B20 CB.
NAVCOM 1 (2) FAILURE
Select and use the remaining NAVCOM (VHF, VOR, DME,
T
ransponder).
NAVCOM 1 (2) OVERHEAT
Pull the associated circuit breaker.
For NAVCOM 1 OVHT, pull the C10 CB.
For NAVCOM 2 OVHT, pull the MRC 2 Electronic CB.
Accomplish the NAVCOM 1 (2) FAILURE Procedure.
PFD 1 (2) FAULT
Crosscheck the affected PFD display information (Attitude, Airspeed,
Altitude, FMA, FPA, Minimuns, Baro setting, Nav-Com radios
frequencies, HDG and CRS) with the opposite side PFD display
information. Disregard any non-reliable information from the affected
PFD.