Embraer 175 - Fms to Non-Precision Loc Approach; Fms to Loc-Bc Approach

AIRPLANE
FLIGHT
MANUAL
SUPPLEMENT 4
PRIMUS EPIC - FLIGHT
MANAGEMENT SYSTEM
ANAC APPROVED S4-10
REVISION 15 code 01 Page 5
Copyright © by Embraer. Refer to cover page for details.
AFM
-
1385
Speed Selector Knob.................................................... FMS
Autopilot........................................................................ ENGAGED
At the FAF:
Speed Selector Knob.............................................. MAN
Speed..................................................................... AS REQUIRED
Approach on PFD................................................... CONFIRM AT
FAF
At 400 ft AGL:
Autopilot.................................................................. DISENGAGE
NOTE: - The APPR annunciator must be monitored throughout final
approach. If the APPR annunciator is not displayed, and the
appropriate runway visibility indicators are not confirmed,
then the pilot should declare a missed approach.
- During approaches with VNAV engaged, the Altitude Pre
Selector must be set to altitudes lower than current airplane
altitude.
- When VGP mode is engaged, the FMS descent path will not
be restricted by the altitude pre-selector.
FMS TO NON-PRECISION LOC APPROACH
There is no procedure to use the FMS to transition automatically to a
non-precision LOC based approach. This includes LOC Only, LDA,
and SDF types. Refer to the FGCS section of this manual for non-
precision LOC procedures.
FMS TO LOC-BC APPROACH
NOTE: This procedure assumes LNAV and VNAV is previously active.
FMS Tune .................................................................... CONFIRM
AUTO
Approach Speeds ......................................................... VERIFY
Go Around Speeds ....................................................... VERIFY
NOTE: FMS does not correct Approach and Go Around speeds for
non-standard conditions.
Preview LOC................................................................. SELECT
Baro Altitude ................................................................. SET
Minimums ..................................................................... SET