Embraer 175 - Hold Pattern

AIRPLANE
FLIGHT
MANUAL
SUPPLEMENT 4
PRIMUS EPIC - FLIGHT
MANAGEMENT SYSTEM
ANAC APPROVED S4-10
REVISION 15 code 01 Page 8A
Copyright © by Embraer. Refer to cover page for details.
AFM
-
1385
HOLD PATTERN
If a Holding Pattern is defined, the pilot must perform the following prior
to sequencing the Hold fix:
Speed............................................................................ AS REQUIRED
Hold Entry Type ............................................................ VERIFY
Hold Inbound Course.................................................... VERIFY
Hold Turn Direction....................................................... VERIFY
Hold Leg Time/Distance ............................................... VERIFY
If the Hold is defined as a Hold to an Altitude, as part of a procedure
from the navigation database, the pilot must select the EXIT prompt on
the FPL page when the Hold Altitude termination point is reached.
NOTE: If Holding patterns are conducted at speeds higher than
210 kt, the crew should monitor position throughout the
maneuver, to ensure protected airspace is maintained. The
Hold pattern may be exited at any time by selecting the EXIT
prompt on the FPL page on the MCDU. If Hold exit is selected
on the outbound leg, guidance will be provided to immediately
turn and capture the inbound course to the Hold fix. If Hold exit
is selected on the inbound leg, guidance will be provided to
continue to the Hold fix. The Hold fix will then be automatically
sequenced.