Procedure
1. Open a browser and enter the IP address of SP A.
2. Use the sysadmin credentials to log in to Unisphere.
You may be prompted by certificate-related warnings. Accept all certificates as
"Always Trust".
3. Select your storage system and select System > Monitoring and Alerts.
If any alerts or warnings are listed in that screen or your dashboard, see the Unisphere
online help for that event.
Install ESRS and configure ConnectHome
You can ensure that your system communicates with your service provider by installing
the EMC Secure Remote Support (ESRS).
If you already have an ESRS Gateway Server, this system can be monitored through it. If
you already have an IP Client, this system can be added to it. If neither of these is used,
EMC recommends setting up ESRS on the Storage Processors. This can be done through
Unisphere.
You will need the information from the worksheet in this publication.
Downloading ESRS documentation and setting up ESRS
Procedure
1. Go to https://mydocs.emc.com/VNX.
2. Under VNX tasks, select Initialize and register VNX for block and configure ESRS.
3. Select the appropriate options for your configuration.
4. Select Install and Configure ESRS to generate a customized version of
EMC Secure
Remote Support for VNX
document.
5. Follow the instructions for the ESRS implementation you choose.
6. Set up ESRS and test the ConnectHome process.
Configure servers for VNX systems
Procedure
1. Go to https://mydocs.emc.com/VNX and from the VNX Server Tasks list, select an
appropriate task such as:
l
Attach server
l
Install or update software (VNX for Block)
l
Verify Server high availability, using Unisphere Server Utility
2. Follow the prompts to generate customized documentation for server tasks.
Provision storage
Provisioning storage includes:
Setup
Install ESRS and configure ConnectHome 71
To Next Page
Loading...
Need help?
General
