Emerson Mentor MP - 5.8 Menu 7: Analog I;O

108 Mentor MP Short Form Guide
www.controltechniques.com Issue Number: 5
8.11 Menu 11: General drive set-up
Parameter
11.21 Parameter scaling
11.22 Parameter displayed at power-up
11.23 Serial address Si02
11.24 Serial mode
11.25 Baud rate Si01
11.26 Minimum comms transmit delay
11.29 Software version di14
11.30 User security code
11.32 Current rating
11.33 Drive voltage rating
11.34 Software sub-version
11.35 Number of modules
11.36 SMARTCARD parameter data previously loaded
11.37 SMARTCARD data number
11.38 SMARTCARD data type / mode
11.39 SMARTCARD data version
11.40 SMARTCARD data checksum
11.41 Status mode timeout
11.42 Parameter copying SE09
11.44 Security status SE14
11.45 Select motor 2 parameters
11.46 Defaults previously loaded
11.47 Drive Onboard Application Lite Ladder Program Enable
11.48 Drive Onboard Application Lite Ladder Program Status
11.49 Drive Onboard Application Lite Ladder Program Events
11.50 Drive Onboard Application Lite Ladder Program Maximum Scan Time
11.51 Drive Onboard Application Lite Ladder Program First Run
11.52 Drive serial number
11.53 Build location
11.55 Drive rating number
11.56 Power PCB software version
11.57 Serial programmable source
11.58 Serial scaling
11.59 Mentor II parameter emulator module control
11.60 Application parameters
11.61 Application parameters
11.62 Full power discharge time
11.63 Full power discharge period
11.64 External discharge resistance
11.65 External resistor temperature
11.66 Suppressor voltage