Emerson Mentor MP - 7 SMARTCARD Operation; Introduction; Easy Saving and Reading

84 Mentor MP Short Form Guide
www.controltechniques.com Issue Number: 5
7 SMARTCARD operation
7.1 Introduction
This is a standard feature that enables simple configuration of parameters in a variety of
ways. The SMARTCARD can be used for:
• Parameter copying between drives
• Saving whole drive parameter sets
• Saving ‘differences from default’ parameter sets
• Storing Onboard PLC programs
• Automatically saving all user parameter changes for maintenance purposes
• Loading complete motor map parameters.
Refer to Figure 7-1 for installing the SMARTCARD. Ensure the SMARTCARD is
inserted with the MP arrow pointing upwards.
The drive only communicates with the SMARTCARD when commanded to read or
write, this means that the card may be ‘hot swapped’.
Figure 7-1 Installation of the SMARTCARD
7.2 Easy saving and reading
The SMARTCARD has 999 individual data block locations. Each individual location from
1 to 499 can be used to store data.
The drive can support SMARTCARDS that have a capacity of between 4kB and 512kB.
The usage of the data block locations in the SMARTCARD are shown in Table 7-1.
Be aware of possible live terminals when inserting or removing the SMARTCARD.
WARNING
P
a
r
a
m
e
t
e
r
-
P
r
0
.
3
0
r
E
A
d
+
A
u
t
o
+
P
r
o
g
+
b
o
o
t
+