Emerson Mentor MP - Page 64

64 Mentor MP Short Form Guide
www.controltechniques.com Issue Number: 5
The display examples in this section show the SM-Keypad 7 segment LED display. The
examples are the same for the MP-Keypad except that the information displayed on the
lower row on the SM-Keypad is displayed on the right hand side of the top row on the
MP-Keypad.
Figure 5-3 Display modes
Figure 5-4 Mode examples
* Can only be used to move between menus if L2 access has been enabled
Pr 11.44 (SE14, 0.35)
**Time-out defined by Pr 11.41 (default value = 240s).
Use
* keys
to select parameter for editing
To enter Edit Mode,
press key
Status
Mode
(Display
not
flashing)
Parameter
Mode
(Upper
display
flashing)
Edit Mode
(Character to be edited in lower line of display flashing)
Change parameter values
using keys.
When returning
to Parameter
Mode use the
keys to select
another parameter
to change, if
required
To exit Edit Mode,
press key
To enter Parameter
Mode, press key or
*
Temporary
Parameter
Mode
(Upper display
flashing)
Timeout**
Timeout**
Timeout**
To return to
Status Mode,
press
key
RO
parameter
R/W
parameter
Pr value 5.05
Menu 5. Parameter 5
Trip type (UV = undervolts)
Drive status = tripped
Trip StatusAlarm Status
Parameter
View Mode
Healthy Status
Status Mode
Do not change parameter values without careful consideration; incorrect values may
cause damage or a safety hazard.
WARNING