7
SMART VENTILATING FAN
Ventilating fan
A ventilating fan is installed inside the radiation shields to reduce the impact of sun heat effect.
The fan is driven by solar panel and will automatically start spinning under 2 conditions:
1. When the sun is shining on the solar panel, and 2. Average windspeed is below 5m/s for 1
minute.
INSTALLATION AND SETUP
Your console can pair up with one wireless 7-in-1 outdoor sensor and up to 7 wireless indoor
sensors. (1PC wireless indoor sensor included)
INSTALL WIRELESS 7-IN-1 SENSOR
Your wireless 7-IN-1 sensor measures wind-speed, wind-direction, rainfall, UV, light intensity,
temperature and humidity for you. It’s assembled and calibrated for your easy installation.
INSTALL BATTERIES
Unscrew the battery door at bottom of unit and insert the
batteries according to the +/- polarity indicated. Screw the
battery door compartment on tightly.
NOTE:
The red LED will begin ashing every 12 seconds.
Screw
location
3 x AA
batteries
MOUNTING KIT INSTALLATION
1. U-bolt x 2 2. Pole mounting
clamps x 4
3. Flat washers
x 4
4. Hex nuts
x 4
5. Stainless steel
pole
To Next Page
Loading...
