Configuration from Embedded Web Server
3. Zone Name: In this option, type an AppleTalk Zone
name that you want the print server to belong to or leave
it in default (This enables the print server automatically
search and link itself to the default zone that is set on the
AppleTalk router, if found). We also assume that at least
an AppleTalk Zone exists on the network. If no any zone
exists, the print server itself displays the zone name as
an asterisk (*) in the current AppleTalk Status of the
print server in the web browser.
4. Port Name: In this option, type a name for identification
purpose or just leave it in default (recommended).
Note: The default print server’s Chooser name is as shown
as follows:
<ATALK_PS>-xxxxxx-1, where xxxxxx represents
the last six digits of the device’s Node ID. For example:
ATALK_PS-40EEED-1. You may also change the
<ATALK_PS> to a name you like for identification
purpose in this option. The print server will append the
last six digits to the name you specify.
5. Printer Type: In this option, the LaserWriter of printer
type by default (recommended).
6. Data Format: In this option, data format includes ASCII,
TBCP and BCP.
5 - 24
To Next Page
Loading...
Need help?
Ports & interfaces