Encore ENPS-2012 - Multi-Segment LAN Environment Installation (through the Network Print Port); RIP for NWLink IPX;SPX compatible transport Installation Procedure

Troubleshooting
procedures in order for your print server to function
properly:
 Add the RIP for NWLink IPX/SPX compatible
transport. See RIP for NWLink IPX/SPX compatible
transport Installation Procedure later in this section.
 Add the frame type 802.2 for both Ethernet adapters.
See
Multi-Segment Frame Type 802.2 Installation
later in this section.
RIP for NWLink IPX/SPX compatible transport
Installation Procedure
1. From your Windows NT server that is used as a
router, select Start from the bottom left hand corner of
the screen.
2. Select Settings.
3. Select Control Panel.
4. Double-click the Network icon.
5. Select Services.
6. Select Add.
7. In the Select Network Service box, select the RIP for
NWLink IPX/SPX compatible transport. Click OK.
8. Follows the directions on the screen.
9. Done!
Multi-Segment Frame Type 802.2 Installation
1. From your Windows NT server that is used as a
router, select Start from the bottom left hand corner of
the screen.
9 - 4