Repair Deltabar PMD75B HART
66 Endress+Hauser
13 Repair
13.1 General information
13.1.1 Repair concept
Under the Endress+Hauser repair concept, devices have a modular design and repairs are
carried out by Endress+Hauser Service or by properly trained customers.
Spare parts are grouped into logical kits with the associated replacement instructions.
For more information on service and spare parts contact Endress+Hauser Service.
13.1.2 Repair of Ex-certified devices
L
WARNING
Limitation of electrical safety due to incorrect repair!
Risk of explosion!
‣
Only specialist personnel or Endress+Hauser-Service can carry out repairs to Ex
certified devices.
‣
Relevant standards and national regulations as well as safety instructions (XA) and
certificates must be observed.
‣
Only genuine Endress+Hauser spare parts may be used.
‣
When ordering spare parts, please check the device designation on the nameplate. Only
identical parts may be used as replacements.
‣
Carry out repairs according to the instructions. Following a repair, the device must
fulfill the requirements of the individual tests specified for that device.
‣
A certified device may be converted to another certified device version by Endress
+Hauser Service only.
‣
All repairs and modifications must be documented.
13.2 Spare parts
• Some replaceable measuring device components are identified by means of a spare part
nameplate. This contains information about the spare part.
• All the spare parts for the measuring device, along with the order code, are listed in the
W@M Device Viewer (www.endress.com/deviceviewer) and can be ordered. If available,
users can also download the associated Installation Instructions.
Measuring device serial number:
• Located on the device and spare part nameplate.
• Can be read out via the device software.
To Next Page
Loading...
Need help?
General
